This is a relatively straightforward kit: clean the contact surfaces carefully, dry-fit repeatedly, glue, and fill. That's it! Depending on the quality of your casting/s, this will either be a non-issue. . . or a non-starter! Fortunately, my castings are such that it is essentially a non-issue.
I have assembled the legs, and reworked the join with MS: the legs are now curing. The "billy club" holster is given rather short shrift; but more curiously, it is on the right(!) leg. While the holster in its various design iterations has appeared on either leg, if at all, canonically it be- longs on the left leg. I decided not to swap legs; instead, opting to enhance and build-out the holster as provided.
Finally, the mounting pegs on the balls of the feet were ground off.
More to follow. . .
No comments:
Post a Comment